New Products

G&P Black Water Silencer 14mm (Black) | Barrel Accessory

A well-crafted aluminum silencer from G&P. It looks nice and comes with some cool detailing. Included Clockwise and Anti-clockwise adaptor.NOTE: FOR AIRSOFT ONLY, THIS PRODUCT IS NOT INTENDED AND...

G&P Multi Magazine Catch for M4 / M16 | Internal Upgrade

Description: -Suitable for left & ri

Modify Baton Ryusoku Hop Up Bucking - Hard Type

Modify - Spring Set

Modify 8mm Steel Bearing Set

Modify - Bearing Set (7mm)

G&G Flora Pin / Center Body Pin | Body Lock Pin

MotoSolutions Fogtech DX Wipe Extended Duration | Single Wipe

MotoSolutions - Fogtech DX Wipe (Extended Duration/Single Wipe) Features: Fogtech DX prevents fogging on plastics and glass, providing crystal clear vision through safety goggles, glasses,...

MotoSolutions Fogtech DX Wipes 12PK

MotoSolutions Fogtech DX Wipes 12PK Features:

PolarStar Fusion Engine Cylinder Input Fitting 6mm

Firefly Namazu Red Flat Hop Nub w/ Roller Bar | Hard

Looking for something that is a little easier to install than R-Hop, but will offer you increased range and accuracy over your stock hop setup? The Namazu FireFly Hop Nub with Spacer will allow you...

PolarStar Fusion Engine V2 M4 | Red Poppet and Nozzle

PolarStar Fusion Engine for M249 | M249 HPA Unit

PolarStar Shim Kit | Fusion Engine Installation Shim Kit

PolarStar Fusion Engine O-Ring Set | Oring Repair Kit

These are the replacement O-Rings for the Polarstar Fusion Engine. This set contains all the O-Rings that are needed to replace worn O-Rings on your Fusion Engine/PR-15.This kit contains the...

Amped Custom - Fusion Engine Poppet Shims | Pack of 4

These poppet shims are used to fine tune your stock or low flow poppet. (If you are purchasing a poppet, you can receive a shim kit at a discounted rate on the Low Flow Poppet item page)Each shim kit...

PolarStar Heavy Nozzle / Poppet Spring - FE/F2/Kythera

PolarStar Fusion Engine Red Low Flow Poppet (.0625)

PolarStar Fusion Engine Gold Low Flow Poppet (.0465)

PolarStar Wire Harness 13" for Fusion Engine, JACK, F1, F2

PolarStar Wire Harness 7.5 for JACK, F1, F2, Fusion Engine

PolarStar Fusion Engine Trigger Board for V2 Gearbox GEN3

PolarStar Bolt Catch Components for Fusion Engine

Amped Airsoft Air Rig Mini Quick Disconnect Plug Gun Side | 6mm

This is the latest connector on the market.  It is much smaller than our existing Quick Detach Couplers. If you are looking for a less bulky connector, then this is the way to go! Gun Side Tubing...

PolarStar Milsim Fitting | 90 Degree Rear Macro Fitting

Amped Line Foster Mini Quick Disconnect Plug | Fitting Only

This fitting is a replacement fitting for your air rig if you happen to need a mini quick disconnect plug.Thread: 1/8" NPT FemaleFound commonly on all of our air rigs. These are also used on our QD...

Amped Line Foster Quick Disconnect QD Regulator Adapter

This adapter is for the use with our new super flexible straight line with quick disconnects to attach to existing regulators. Connects to existing regulator that utilize 1/8" NPT female threads. ...

Foster Male 1/8" NPT Quick Disconnect Plug HPA | Mag Fitting

If you are a GBB user that has wanted to get away from using Green gas, and wanted to use something like HPA for Cold Weather performance, then this is the fitting for you.Features a threaded end for...

HPA Mini Lipo | 7.4v Mini Lipo Battery | 250mah JST

HPA Mini Lipo | 7.4v Mini Lipo Battery | 250mah JST This airsoft battery provides 10-20k shots per charge with a PolarStar Fusion Engine while fitting into a standard "lipo ready" buffer tube...

Condor Cross Draw Vest | Black, Coyote, and OD Green

Amped Airsoft JST BEC Red Connector Male Lead

This is the Male JST connector with wire lead.  This is typically found on most FCUs or considered the "gun side" connector.   Disclaimer: This is a male JST (Gun Side) Connector.  The orientation...

Amped Airsoft JST BEC Red Connector Female Lead

This is the Female JST connector with wire lead.  This is typically found on most batteries or considered the "battery side" connector.   Disclaimer: This is a female JST (Battery Side)...

Amped Airsoft | 2PK Deans AMASS Male Plug Connectors

This package contains two Male Deans Connectors. The industry standard in high performance connectors. The Deans AMASS Plug actually has less resistance, including the solder joints, than an...

Amped Airsoft | 2PK Deans AMASS Female Plug Connectors

This package contains two Female Deans Connectors. The industry standard in high performance connectors. The Deans AMASS Plug actually has less resistance, including the solder joints, than an...

G&G Combat Machine CM16 Raider Long Airsoft AEG (Black)

G&G Combat Machine CM16 Raider Short Airsoft AEG (Black)

G&G Combat Machine CM16 Carbine (Black)

Knights Armament Airsoft - Stoner LMG

Amped Line | Amped HPA Line Standard Weave

The Amped Line was developed during the rise in popularity of High Pressure Air (HPA) Airsoft systems in the United States. We, as avid players, wanted a better solution to air delivery than...

Amped Airsoft Barrel Cover Airsoft Replica Barrel Cover

Amped Airsoft Barrel Cover Airsoft Replica Barrel Cover A barrel cover from Amped Airsoft that has the Amped Airsoft Logo. This airsoft barrel cover can be placed on your replica with ease when...

Amped Airsoft SLP Regulator | Amped HPA SLP Rig

Amped Airsoft SLP Regulator | Amped HPA SLP Rig  This airsoft regulator is what we like to call our SLP (Super Low Pressure) Air Rig. This system incorporates a robust single regulator that allows...

Amped Airsoft Amped Grip Line 90 Degree AGL90

AMPED Grip Line (AGL) is a large bore line for your PolarStar Fusion Engine or Wolverine SMP that is both flexible and durable. It is enclosed in a nylon sheathing that will not affect it's...

Amped Standard Weave AGL 2.0 | Amped Grip Line 2.0

The Amped Grip Line 2.0 (AGL 2.0) is an upgraded large bore grip line that attaches to the existing 6mm macro line in the pistol grip. The AGL uses a slip fitting that allows for a quick and easy...

Cold Steel Rubber Training Knife Leather Neck SF Trainer

Blade Length: 7" Overall Length: 12" Material: Santoprene Weight: 4.1 oz Handle: 5" Long   Now you can practice with some of our most popular knife designs, in relative safety, with our new...

Cold Steel Rubber Training Knife Military Classic

Specifications: Blade Length: 6 3/4" Overall Length: 11 1/2" Material: Santoprene Weight: 3.2 oz Handle: 4 3/4" Long   Now you can practice with some of our most popular knife designs, in...

Cold Steel Rubber Training Knife Recon Tanto

Specifications: Blade Length: 7" Overall Length: 11 3/4" Material: Santoprene Weight:3.1 oz Handle: 4 3/4" Long   Now you can practice with some of our most popular knife designs, in...

Ninja 7500psi Burst Disk Assembly (Black)

Alta FLEX Knee Pads AltaLok | Black

Strong durable kneepad design  Long cap offers maximum surface coverage  Cordura® Nylon cover  "Compression Recovery" 1/2" Neoprene foam padding provides firm, consistent support without...

Dye | i4 Thermal Mask DyeCam

Dye i4 Thermal Mask Black Face Protection

Revision Desert Locusts Black / Clear

KWA ATP Adaptive Training Pistol Magazine